V7 Beta 9 Repair and Extract - Crash on Combine Splits of certain archives

[LordCrc]

I think I got the split-set crash bug fixed in this unofficial test release :

http://www.newsleecher.com/nl70010.ufr3.exe

Cheers. I tested it on a few of the ones which insta-crashed beta9, and it worked fine. A couple needed repair so that worked as well.

[Eric10301]

I think I got the split-set crash bug fixed in this unofficial test release :

http://www.newsleecher.com/nl70010.ufr3.exe

I just tested one and it didn't work. I'll send you a pm with the post.

[Bittorrrrent]

I had a download in Repair and Extract that was stuck at combining so this was a good way to test if it fixes it. After installing the unofficial Beta 10 it extracted normally.

[Spiril]

Hi Eric,

I just tested one and it didn't work. I'll send you a pm with the post.

I tried the PAR2 set you PMed me, and the reason it isn't working is because it's doesn't follow the normal naming method for PAR2 split set files. I have implemented support for it anyway though, in the following unofficial test release :

http://www.newsleecher.com/nl70010.ufr5.exe

[Eric10301]

Hi Eric,

I just tested one and it didn't work. I'll send you a pm with the post.

I tried the PAR2 set you PMed me, and the reason it isn't working is because it's doesn't follow the normal naming method for PAR2 split set files. I have implemented support for it anyway though, in the following unofficial test release :

http://www.newsleecher.com/nl70010.ufr5.exe

Looking good so far, thanks. Hopefully you can work out the other bug thread I posted.